Aiwa CSD-EL300 English, Precautions, Explanation of Graphical Symbols, Owner’s record

Page 2

ENGLISH

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS- TURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.”

Explanation of Graphical Symbols:

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral trian- gle is intended to alert the user to the presence of important operating and maintenance (servic- ing) instructions in the literature accompanying the appliance.

PRECAUTIONS

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instruc- tions and on the unit should be strictly followed, as well as the safety suggestions below.

Installation

1Water and moisture – Do not use this unit near water, such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, swimming pool, or the like.

2Heat – Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5˚C (41˚F) or greater than 35˚C (95˚F).

3Mounting surface – Place the unit on a flat, even surface.

4Ventilation – The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from the each side.

-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.

-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.

5Objects and liquid entry – Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands – When placed or mounted on a stand or cart, the unit should be moved with care.

Quick stops, excessive force, and uneven surfaces may cause the unit or cart to

overturn or fall.

7Condensation – Moisture may form on the CD pickup lens when:

-The unit is moved from a cold spot to a warm spot

-The heating system has just been turned on

-The unit is used in a very humid room

-The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

8Wall or ceiling mounting – The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions.

Electric Power

1Power sources – Use on batteries or AC house current, as specified in the Operating Instructions and marked on the unit.

2Polarization – As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.

-Never handle the AC power plug with wet hands, as this could result in fire or shock.

-Power cords should be firmly secured to avoid being bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.

-Avoid overloading AC outlets and extension cords beyond their capacity, as this could result in fire or shock.

4Extension cord – To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure of the blades of the plug.

5When not in use – Unplug the AC power cord from the AC outlet or remove all the batteries if the unit will not be used for several months or more. When the cord is plugged in, a small amount of current continues to flow to the unit, even when the power is turned off.

Maintenance

Clean the unit only as recommended in the Operating Instructions.

Damage Requiring Service

Have the unit serviced by a qualified service technician if:

-The AC power cord or plug has been damaged

-Foreign objects or liquid have gotten inside the unit

-The unit has been exposed to rain or water

-The unit does not seem to operate normally

-The unit exhibits a marked change in performance

-The unit has been dropped, or the cabinet has been damaged

DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.

Owner’s record

For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty.

Model No.

Serial No. (Lot No.)

CSD-EL300

2 ENGLISH

Image 2
Contents CSD-EL300 English PrecautionsExplanation of Graphical Symbols Owner’s recordTable of Contents Power Supply Remote ControlPress the Enter or abutton to complete the setting Before Operation Setting the ClockTurn the VOLUME/TIMER control to adjust the clock Press the Clock buttonEqualizer Mode Adjusting the SoundVolume Control Super T-BASS SystemTape Operations To select a reverse modeTo change the playback side, press the dbutton in play mode Inserting a TapePress the for g button to select a station Manual TuningTo change the AM tuning interval To search for a station quickly Auto SearchPresetting Stations Repeat steps 1Loading a Disc Press the dbutton or the cbutton on the remote controlCD Operations Playing a DiscProgrammed Play Random PlayRepeat Play Insert the tape to be recorded RecordingInserting Blank Spaces Press the wREC/REC Mute button to start recordingSetting the Sleep Timer Press the Enter buttonTuner Section Care and MaintenanceTroubleshooting Guide Cassette Deck SectionSpecifications CopyrightAdvertencia EspañolPrecauciones Explicación de los símbolos gráficosÍndice USO CON LAS Baterías AlimentaciónMando a Distancia Cómo Insertar BateríasAjuste DEL Reloj Gire el control VOLUME/TIMER para ajustar el relojAntes DE LA Operación Pulse el botón ClockSistema Super T-BASS Control DEL VolumenAjuste DEL Sonido Sistema Q SurroundCómo Insertar UNA Cinta Reproducción DE UNA CintaCómo cambiar el intervalo de sintonización AM Sintonización ManualPulse el botón f o gpara seleccionar una emisora Cómo buscar una emisora rápidamente AutobúsquedaOtro método para seleccionar una presintonía Sintonización Mediante PresintoníasEjemplo Cómo borrar una presintoníaReproducción DE UN Disco Operaciones CON LOS Discos CompactosCómo Cargar UN Disco Pulse el botón do el botón cdel mando a distanciaReproducción Aleatoria Repetición DE LA ReproducciónCargue la cinta en la que desea grabar GrabaciónInserción DE Espacios EN Blanco Pulse el botón wREC/REC Mute para iniciar la grabaciónPulse el botón Enter Prepare la fuente que desea escuchar ApagadofHora de activación del temporizador Pulse el botón SleepSección DEL Casete Solución a Pequeños ProblemasSección DEL Sintonizador Sección DEL Reproductor DE Discos CompactosSección del sintonizador de AM EspecificacionesSección del sintonizador de FM Sección de la platinaPrécautions Explication des symboles graphiquesFrançais AvertissementLecture DE Cassette PréparatifsSON Réception RadioTélécommande Alimentation FournieRéglage DE Lhorloge Avant LA Mise EN ServiceTournez la commande VOLUME/TIMER pour régler lhorloge Appuyez sur la touche ClockRéglage DU SON Commande VolumeMode Égaliseur Système Super T-BASSInsertion Dune Cassette Pour sélectionner un mode dinversionOpérations DE Base Lecture Dune CassettePour changer lintervalle daccord AM Accord ManuelAppuyez sur la touche f ou gpour sélectionner une station Pour une meilleure réceptionExemple Préréglage DE StationsAccord PAR Numéro DE Préréglage Autre méthode pour sélectionner un numéro de préréglageChargement DE Disques Appuyez sur la touche dou sur la touche Sur la télécommandeSélection dune piste avec la télécommande Lecture DE DisquesLecture Programmée Lecture AléatoireLecture Répétée Insérez la cassette à enregistrer EnregistrementInsertion Despaces Vierges PréparatifsAppuyez sur la touche Enter Préparez la source Pour vérifier le réglage de la minuterieSection Platine Cassette Guide DE DépannageSection Tuner Section Lecteur DE CDSpécifications Droits DauteurParts Index / Índice DE LOS Componentes / Index