GENERAL
CARE AND MAINTENANCE
Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.
To clean the cabinet Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.
To clean the heads
When the tape heads are dirty;
-high frequency sound is not emitted
-the sound is not adequately high
-the sound is
-the tape cannot be erased
-the tape cannot be recorded on
After every 10 hours of use, clean the tape heads with a head cleaning cassette.
Use separately sold
To demagnetize the heads
The heads may become magnetized after
Care of discs
•When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.
•After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.
Care of tapes
•Store tapes in their cases after use.
•Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.
•Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.
TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating Instructions, check the following guide.
GENERAL
There is no sound.
•Is the AC cord connected properly?
•If you intend to use the unit on batteries, are the batteries correctly inserted?
•Was an incorrect function button pressed?
An erroneous display or a malfunction occurs.
→Reset the unit as stated below.
TUNER SECTION
The reception contains noise interferences or the sound is distorted.
•Is the unit picking up external noise or multipath distortion?
→Change the orientation of the antenna or the unit.
→Move the unit away from other electrical appliances.
CASSETTE DECK SECTION
The tape does not run.
• Is the deck in pause mode? (→ page 7)
The sound is
•Is the playback head dirty? (→ page 14)
Recording is not possible.
•Is the erasure prevention tab on the tape broken off? (→ page 7)
•Is the recording head dirty? (→ page 14)
Erasure is not possible.
•Is the erasure head dirty? (→ page 14)
•Is a metal tape or CrO2 tape being used?
High frequency sound is not emitted.
•Is the recording/playback head dirty? (→ page 14)
The tape is not removed.
→If you try to use the unit when the batteries are depleted, the tape may stop during play or recording, and the cassette holder will not open.
Should this occur, replace the batteries with new ones or connect the supplied AC cord to the unit, then remove the tape.
CD PLAYER SECTION
The CD player does not play.
•Is the disc correctly inserted? (→ page 10)
•Is the disc dirty? (→ page 14)
•Is the lens affected by condensation?
→ Wait approximately one hour and try again.
To reset
If an unusual condition occurs in the display window or the cassette deck, reset the unit as follows.
1Press the POWER button to turn off the power.
2Press the POWER button to turn the power back on while
pressing the sbutton. Everything stored in memory after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord and remove all the batteries, and then repeat step 2.
14 ENGLISH