Kenmore 10656704500 Chilled Door Bin Control, Drop-In Door Rails To Remove and Replace the Rails

Cool air from the freezer is directed to the door bin directly beneath the vent.

NOTE: The dairy compartment and can rack are not chilled.

Chilled Door Bin Control

The chilled door bin control is located on the left-hand side of the refrigerator compartment.

Turn the control clockwise (right) to reduce the flow of cold air to the bin and make it less cold.

Turn the control counterclockwise (left) to increase the flow of cold air to the bin and make it colder.

The door rails or bins may be removed for easier cleaning.

Snap-On Door Rails or Bins

To Remove and Replace the Rails or Bins:

1.Remove the rails or bins by pushing in slightly on the front of the bracket while pulling out on the inside tab. Repeat these steps for the other end of the rail or bin.

2.Replace the rails or bins by aligning the ends of the brackets with the buttons on the sides of the door liner. Firmly snap bracket onto the tabs above the shelf as shown.

Drop-In Door Rails

To Remove and Replace the Rails:

1.Remove the rails by pulling straight up on each end of the rail.

2.Replace the rails by sliding the shelf rail into the slots on the door and pushing the rail straight down until it stops.

To Remove and Replace the Bins:

1.Remove the bin by lifting it and pulling it straight out.

2.Replace the bin by sliding it in above the desired supports and pushing it down until it stops.

To Remove and Replace the Bin:

1.Remove the bin by lifting it and pulling it straight out.

2.Replace the bin by sliding it in above the desired supports and pushing it down until it stops.

To Remove and Replace the Bin Parts:

1.Press either release button to open the tilt-out portion of the bin.

A

A.Release buttons

2.To remove the tilt-out portion of the bin, press in on the curved levers on each side of the bin. Pull up and out.

18