Nilfisk-Advance America BRX 700 Series manual English / A-7, Filling the Solution Tank

ENGLISH / A-7

FILLING THE SOLUTION TANK

1Open the Solution Tank Fill Cover (2).

2Read the dilution instructions on the chemical container. Then figure the proper amount of chemical to mix with 40 gallons (151 liters) of water.

3Pour the proper amount of chemical into the solution tank and fill the tank with warm water to 7.62cm (3 inches) from the top of the tank opening.

4Close the Solution Tank Fill Cover (2).

NOTE: If your machine was factory equipped with a chemical system you DO NOT mix chemical in the solution tank.

CAUTION!

Use low-sudsing, liquid detergents designed for carpet extraction. Water temperature should not exceed 130 degrees Fahrenheit (54.4 degrees Celsius).

BEFORE USING THE AQUARIDE™ SE / BRX 700

Thorough vacuuming of the carpet to be cleaned is not necessary before using the AquaRide™ SE or BRX 700 automatic extractors, due to the on-board sweeping broom and debris hopper.

PRE-SPRAYING THE CARPET

Pre-spray spots and heavy traffic areas before extracting. Use a hand-held bottle sprayer or a pressurized “Hudson” type sprayer. Mix the pre-spray according to the chemical manufacturer’s directions.

PLAN FOR CLEANING

Before you begin extracting, look at the area to be cleaned and plan your work. Divide the space into sections. Overlap each pass 2 inches (5 cm).

FORM NO. 56041541 - AquaRide™ SE, AquaRide™ SE AXP / BRX 700 series - A-7