Simpson V3100 warranty Accessories, Trouble Shooting Guide

Page 16

ACCESSORIES

Recommended accessories for use with our pressure washer are available for purchase from your local retailer or authorized service center. if you need assistance in locating any accessory for your pressure washer, please go to www.power-washer.us

Risk of ﬂ uid injection. When using replacement lances or guns with this pres- sure washer, DO NOT use a lance and/or lance/gun combination that is shorter in length than what was provided with this pressure washer as measured from the nozzle end of the lance to the gun trigger.

The use of any other accessory not recommended for use with this tool could be haz- ardous. use only accessories rated equal to or greater than the rating of the pressure washer.

TROUBLE SHOOTING GUIDE

	PROBLEM	CAUSE	CORRECTION
	Engine will not	No Fuel	Add fuel.
	start (see Engine
	start (see Engine	Pressure builds up after two pulls on	Squeeze gun trigger to relieve pres-
	manual for further	Pressure builds up after two pulls on	Squeeze gun trigger to relieve pres-
	manual for further	the recoil starter or after initial use.	sure.
	troubleshooting).	the recoil starter or after initial use.	sure.

		Choke level in the “No Choke” position.	Move choke to the “CHOKE” position.
		Choke level in the “No Choke” position.	Move choke to the “CHOKE” position.

		Spark plug wire not attached.	Attach spark plug wire.

		Engine Switch in the “OFF” Position.	Place engine switch in “ON” Position.

		Choke lever in the “CHOKE” position	Move choke to the “NO CHOKE” posi-
		on a “hot” engine or an engine that has	tion.
		been exposed to thermal heat for a
		long period of time.
	No or low pressure	Variable Spray Wand not in High Pres-	See How to Use Spray Wand instruc-
	(initial use).	sure Position.	tions.

		Low Water Supply.	Water Supply must be at least 5 GPM
			and 20 PSI.

		Leak at high pressure hose ﬁ tting.	Repair Leak. Apply sealant tape if
			necessary.

		Nozzle Obstructed.	See Nozzle Cleaning instructions.

		Water Filter Screen Clogged.	Remove and clean ﬁ lter.

		Air in hose.	Turn off the engine, then the water
			source. Disconnect the water source
			from the pump inlet and turn the water
			source on to remove all the air from the
			hose. When a steady stream of water
			is present, turn the water source off.
	Continued on next		Re-connect water source to pump inlet
	Continued on next		and turn on water source. Squeeze
	page.		and turn on water source. Squeeze
	page.		trigger to remove remaining air.
			trigger to remove remaining air.

16

Image 16

Contents 3100 Safety Guidelines Definitions Consumer Safety InformationImportant Safety Instructions Risk of Explosion or Fire What can Happen HOW to Prevent ITWhat can Happen HOW to Prevent IT Treat Fluid Injection AS a Simple Risk of Injury from SprayRisk of Unsafe Operation What can Happen HOW to Prevent IT Risk of Bursting What can Happen HOW to Prevent IT Risk of HOT SurfacesSpecifications Risk of Chemical Burn What can Happen HOW to Prevent ITRisk of Electrical Shock Risk of Injury from LiftingCarton Contents Assembly Instructions Operating Instructions Basic Elements of a Pressure WasherBasic Elements of AN Engine Pressure Washer Operating Features Spray WandPressure Washer Terminology Pressure Washer Operating Features Spray Wand Changing Nozzle on the Spray WandHow to Apply Chemicals / Cleaning Solvents Changing Nozzles on Spray WandDetergent Siphon Hose Detergent TankStarting Your Pressure Washer Shutting Down Your Pressure WasherMaintenance Engine Pump Nozzle CleaningClean the Water Inlet Filter StorageRepairs Engine PumpAccessories Trouble Shooting GuideTrouble Shooting Guide Warranty Statement Simpson Warranty on NextAccessories High Pressure Electric Axial PumpsHigh Pressure Gas Axial Pump High Pressure Triplex PumpPage Indice de materias ImportanteInformación DE Seguridad Para EL Consumidor Definiciones DE Normas DE SeguridadInstrucciones Importantes DE Seguridad ¿QUÉ Puede SUCEDER? Cómo Evitarlo Trate LA Inyección DE Líquido Como Riesgo DE Inyección DE Líquido Y LaceraciónRiesgo DE Lesión POR Pulverización Page Riesgo DE DE Estallido ¿QUÉ Puede SUCEDER? Cómo Evitarlo Especificaciones DEL Producto Riesgo DE Quemadura QuímicaRiesgo DE Descarga Eléctrica Riesgo DE Lesión POR Levantar Mucho PesoContenido DE LA Caja Instrucciones Para Armar Instrucciones DE Operación Elementos Básicos DE UNA Lavadora a PresiónElementos Básicos DEL Motor Terminología DE LA Lavadora a PresiónCambiando la boquilla en la vara rociadora Cambiando la boquilla en la vara rociadora continuación Cómo Aplicar Sustancias Químicas/Limpiando SolventesManga de Sifon de Detergente Tanque DE DetergenteArranque ApagadoMotor MantenimientoBomba Limpieza DE LA Boquilla Reparaciones Limpie LA Cala de Agua FiltraBomba Lavadora a PresiónGuía DE Diagnóstico DE Problemas AccesoriosGuía DE Diagnóstico DE Problemas Declaración DE Garantía Simpson Cleaning Systems Page Manuel D’INSTRUCTIONS Table des matièresMesures DE Sécurité Définitions CE QUI Peut SE Produire Comment Léviter Risque Dasphyxie CE QUI Peut SE Produire Comment LéviterPAS Traiter UN Injection DE Liquide Risque DE Blessure PAR JETPage Risque Déclatement Risque DE Brûlure Chimique Risque Dechoc ÉlectriqueRisque DE Blessure EN Soulevant LE Produit Lisez ET Conservez CES InstructionsDassemblage Utilisation Éléments DE Base DU Moteur Terminologie DES Laveuses À PressionChangement de buse sur le tube d’arrosage Changement de buse sur le tube d’arrosage suite Comment Appliquer Produits chimiques/Nettoyant DissolvantsTuyau Detergent DE Siphon Réservoir À DétergentDémarrage Arrêt DE LappareilMoteur PompeNettoyage DE LA Buse Nettoyage DU Filtre Dentrée DeauNettoyer L’ARRIVEE D’EAU Filtre EntreposageLaveuse À Pression Problema Causa Corrección RéparationsProblème Cause Correction Guide DE Dépannage Garantie Page