Shindaiwa EB3410/EVC, EB2510/EVC, 68907-94311 manual Troubleshooting Guide

Page 13

Troubleshooting Guide

ENGINE DOES NOT START

What To Check				Possible Cause				Remedy
		NO		Faulty recoil starter.
Does the engine crank?		NO		Faulty recoil starter.				Consult with an authorized
Does the engine crank?				Fluid in the crankcase.

								servicing dealer.
								servicing dealer.
YES				Internal damage.
YES
		NO		Loose spark plug.				Tighten and re-test.

Good compression?

				Excess wear on cylinder, piston, rings.				Consult with an authorized



YES								servicing dealer.
YES
		NO		Fuel incorrect, stale, or contaminated;				Refill with clean, fresh unleaded

Does the tank contain fresh
				mixture incorrect.				gasoline with a pump octane of 87 or
				mixture incorrect.				gasoline with a pump octane of 87 or
fuel of the proper grade?								higher, mixed with a 2-cycle air cooled
								mixing oil that meets or exceeds ISO-L-
								mixing oil that meets or exceeds ISO-L-
								EGD and/or JASO FC classified oils at
YES								50:1 gasoline/oil ratio.
YES
		NO		Check for clogged fuel filter and/or vent.				Replace fuel filter or vent as required.


Is fuel visible and moving in
								Re-start.
								Re-start.
the return line when priming?				Priming pump not functioning properly.				Consult with an authorized


YES								servicing dealer.
YES

Is there spark at the spark plug wire terminal?

YES

NO

The ignition switch is in “O” (OFF) position.

Shorted ignition ground.

Faulty ignition unit.

Move switch to “I” (ON) position and re-start.

Consult with an authorized servicing dealer.

Check the spark plug.

If the plug is wet, excess fuel may be in the cylinder.

The plug is fouled or improperly gapped.

The plug is damaged internally or of the wrong size.

Crank the engine with the plug removed, re-install the plug and re-start.

Clean and re-gap the plug to 0.6 mm (0.024 in.). Re-start.

Replace the plug with a NGK CMR5H or equivalent resistor type spark plug of the correct heat range. Set spark plug electrode gap to 0.6mm (0.024 in.).

13

Image 13

Contents EB2510/EVC Blower EB3410/EVC Blower Introduction ContentsWork Safely General Safety InstructionsStay Alert Use Good JudgmentBe Aware of the Working Environment Properly Equipped OperatorPrior to Assembly SpecificationsUnit Description Assembling the Blower Mixing Fuel Starting ProcedureFilling the Fuel Tank Starting the EngineWhen The Engine Starts Adjusting Engine Idle SpeedIf The Engine Does Not Start Starting a Flooded EngineThrottle Control Using The BlowerDaily Maintenance MaintenanceEvery 10 Hours Prior to each workday, perform the followingValve Adjustment 139/150-Hour MaintenanceEvery 10/15 Hours Every 50 HoursLong Term Storage Spark Arrester MaintenanceTroubleshooting Guide Engine is knocking Is the engine overheating?Engine stops abruptly Poor accelerationEngine difficult to shut off Excessive vibrationEmission System Warranty Statement Page Part Number Revision 3/07 Manual Del Propietario/Operador Shindaiwa Sopladora EB2510/EVC Sopladora EB3410/EVCÍndice Introducción Notas de Interés Especial¡IMPORTANTE Trabaje de manera segura Instrucciones Generales de SeguridadManténgase alerta Utilice su sentido comúnPreste Atención al Entorno de Trabajo Operador Adecuadamente EquipadoEspecificaciones Descripción de la UnidadAntes de Proceder con el Armado ¡ADVERTENCIA! ¡Peligro con rotación del rotor Armondo La SopladoraLlenado del Tanque de Combustible Mezclado del CombustibleArranque del Motor Disminuya el riesgo de incendiosAjuste de la Marcha Ralentí del Motor Arranque del Motor continuaciónUso de la Sopladora Función del AceleradorMantenimiento Diario MantenimientoCada 10 Horas Antes de comenzar cada día de trabajo, realice lo siguienteCada 50 Horas Cada 10 a 15 HorasMantenimiento Cada 139/150 Horas Más frecuentemente si observa que cae el rendimientoGuardachispas Mantenimiento Cada 139/150 Horas continuaciónAlmacenamiento Prolongado ImportanteEL Motor no Arranca Guía de Localización de FallasQue Revisar Posible Causa Solución Que Revisar Baja Potencia DE SalidaSíntoma Problemas AdicionalesSus Derechos y Obligaciones de Garantía Esta garantía es administrada porCobertura de la Garantía del Fabricante Que Está Cubierto Por Esta GarantíaNotas Shindaiwa Inc Corporación de Shindaiwa Souffleur EB2510/EVC Souffleur EB3510/EVC Table des matières Introduction Mises en gardeTravailler en toute sécurité Mesures de sécurité généralesDemeurer alerte Faire preuve de jugementTenir compte de l’environnement de travail ’utilisateur bien équipéCaractéristiques techniques Description de l’appareilAvant l’assemblage Français Assembler la SoufflerieRemplissage du réservoir à essence Mélange d’essenceDémarrage du moteur Réduisez les risques d’incendieRéglage du régime de ralenti du moteur Démarrage du moteur suiteUtilisation du souffleur Commande d’accélérationEntretien quotidien EntretienAprès 10 heures Plus souvent dans des conditions poussiéreusesAprès 50 heures Toutes les 10 à 15 heuresToutes les 139 à 150 heures Plus fréquemment en cas de baisse de la performanceEntretien du Pare-étincelles Toutes les 139 à 150 heures suiteRemisage à long terme LE Moteur NE Démarre PAS Guide de dépannagePuissance Insuffisante Cause probable SolutionProblème Autres Problèmes Problème Cause probable SolutionDéclaration de garantie du dispositif antipollution Remarques Remarques Remarques