INSTALLATION
Laying the boundary wire in towards the charging |
|
station | 1. |
On its way toward the charging station, the boundary wire |
|
can be laid completely outside the charging station (see | 2. |
option 1 in the figure). If there is a need to partly locate |
the charging station outside the working area, it is also possible to lay the wire under the charging station plate (see option 2 in the figure).
However most of the charging station must not be placed outside the working area as the robotic lawnmower
can then find it difficult to find the charging station (see figure).
Splicing the boundary wire
Use an original coupler if the boundary wire is not long enough and needs to be spliced. It is waterproof and gives a reliable electrical connection.
Insert both wire ends in the coupler. Check that the wires are fully inserted into the coupler so that the ends are visible through the transparent area on the other side of the coupler. Now press down the button on top of the coupler fully. Use a pair of pliers as the button on the coupler is difficult to press down by hand.
IMPORTANT INFORMATION
Twinned cables, or a screw terminal block that is insulated with insulation tape are not satisfactory splices. Soil moisture will cause the wire to oxidise and after a time result in a broken circuit.
English - 26