Husqvarna 320, 330X manual Troubleshooting

TROUBLESHOOTING

Outside working area	The boundary wire connections to	Check that the boundary wire is connected
	the charging station are crossed.	correctly.
	The boundary wire is too close to the	Check that the boundary wire has been laid
	edge of the working area.	according to the instructions. See 3 Installation
		on page 15.
	The working area slopes too much	Check that the boundary wire has been laid
	by the boundary loop.	according to the instructions. See 3 Installation
		on page 15.
	The boundary wire is laid in the	Check that the boundary wire has been laid
	wrong direction around an island.	according to the instructions. See 3 Installation
		on page 15.
	Disturbances from metal objects	Try moving the boundary wire.
	(fences, reinforcement steel) or
	buried cables close by.
	The robotic lawnmower finds it hard	Place the robotic lawnmower in the charging
	to distinguish the signal from an	station and generate a new loop signal.
	installation close by.	See 6.5 Security on page 45.
Wrong PIN code	Wrong PIN code has been entered.	Enter the correct PIN code. Contact the local
	Five attempts are permitted, and	dealer if you forget the PIN code.
	the keypad is then blocked for five
	minutes.
No drive	The robotic lawnmower has got	Free the robotic lawnmower and rectify the
	caught in something.	reason for the lack of drive. If it is due to wet
		grass, wait until the lawn has dried before
		using the robotic lawnmower.
	The working area includes a steep	Maximum guaranteed slope is 45%. Steeper
	slope.	slopes should be isolated. See 3.4 Installation
		of the boundary wire on page 21.
	The guide wire is not laid at an angle	If the guide wire is laid on a slope, it must be
	on a slope.	laid at an angle across the slope. See 3.6
		Installation of the guide wire on page 28.
Charging station	The contact between the charging	Put the robotic lawnmower in the charging
blocked	strips and contact strips may be poor	station and check that the charging strips
	and the robotic lawnmower has made	and contact strips make good contact.
	a number of attempts to charge.
	An object is obstructing the robotic	Remove the object.
	lawnmower.
Stuck in charging	There is an object in the way of the	Remove the object.
station	robotic lawnmower preventing it from
	leaving the charging station.
Upside down	The robotic lawnmower is leaning too	Turn the robotic lawnmower the right way up.
	much or has turned over.
Needs manual	The robotic lawnmower is set to the	Place the robotic lawnmower in the charging
charging	Secondary area operating mode.	station. This behaviour is normal and no action
		is required.
Next start hh:mm	The timer setting prevents the robotic	Change the timer settings. See 6.3 Timer on
	lawnmower from operating.	page 42.

English - 77