
Setting System Administrator Information
| The NETBuilder II bridge/router contains a | |
| set the date after each reboot to keep it correct. | |
| For more information on these parameters, refer to Reference for NETBuilder | |
| Family Software. Proceed to the next section to enter system administrator | |
| information. | |
|
| |
Setting System | As system administrator, you can set the system name, location, and system | |
Administrator | contact so that other system administrators can contact you for information. If you | |
Information | are planning to use SNMP, you must set the system administrator information; | |
| otherwise, these settings are optional. | |
| Before performing the procedure, you need to decide on or obtain the following | |
| information: | |
| ■ | System name |
| ■ | System location |
■ System contact person and phone number
To set system administrator information, follow these steps:
1Specify a name for the node, using:
SETDefault
For example, to set the bridge/router name as “Sales.SanJose,” enter:
SETDefault
The system name can contain no more than 255 characters. The default value is “ “ (null string).
2Specify the system location, using:
SETDefault
For example, to set the system location as “SecondFloor.Lab,” enter:
SETDefault
The system location can contain no more than 255 characters. The default value is “ “ (null string).
3Specify a string that identifies the contact person managing the bridge/router, using:
SETDefault
For example, to specify John Smith as the system contact and a number to reach him, enter:
SETDefault
The system contact string can contain no more than 255 characters. The default value is “ “ (null string). Users can obtain this information by entering:
SHow
Proceed to the next section to assign an Internet address.