Configuring the Primary Boot Source 5-3
8. Dump Destination | Do not dump |
9.Recovery Procedure
10.MP Boot Source
11. Boot Statistics | Booted: 7 | Exceptions: 3 |
Enter parameter number or press Q to quit: |
| |
Enter 4 to select Primary Boot Source.
Information similar to the following is displayed:
Primary Boot Source: |
| |
1. | Boot Device: | Drive A: |
2. | Default file source | Local: |
3. | Maximum retries | 0 |
4. | I/O Module Parameters Ethernet | |
5. | Boot Protocol | TFTP Local configured addresses |
6. | IP Addresses | client:none |
|
| Subnet Mask:none |
7. | MAC Address System | |
8. | ARP Format | Canonical |
9. | FTP Login Parameters |
|
Enter parameter number or press Q to quit:
8Enter 1 to select Boot Device.
Information similar to the following is displayed:
Primary Boot Device:
Local: Drive A:
1.Local
2.Network
Choose Primary Boot Device or press Q to quit:
9Enter 2 to select Network.
Information similar to the following is displayed:
Network Boot:
Choose a slot :
10Enter the slot number where the CEC 20 is installed. For example, type 7 to specify slot 7.
Information similar to the following is displayed:
Boot Filename: boot.29k
Enter Boot Filename (CR=no change):
11Select the NETBuilder bridge/router software version 10.1 as the default boot source file by entering:
/primary/boot.29k
Information similar to the following is displayed:
Primary Boot Device:
Network: Slot 7: /primary/boot.29k
1.Local
2.Network
Choose Primary Boot Device or press Q to quit:
