INSTALLING SOFTWARE AND BOOTING

2 A DPE NETBUILDER II SYSTEM

This chapter contains the following procedures:

Installing and booting NETBuilder software

Making a backup copy of the software flash memory card

Installing Software

and Performing Initial

Boot

NETBuilder software can be installed in the following ways:

From a flash memory card with preinstalled software. 3Com recommends this method.

EZBuilt NETBuilder II systems have a factory-installed software flash memory card. To boot your EZBuilt system, refer to “Booting an EZBuilt NETBuilder II System.”

For component NETBuilder II systems to boot from a flash memory card, they mus have a flash memory drive installed. For installation instructions, refer to the NETBuilder II Flash Memory Drive Installation Guide. After you have installed a flash memory drive, refer to “Booting a Component NETBuilder II System” on page 2-2for instructions on booting your system.

From CD-ROM on a UNIX-based or PC-based network management station using TFTP

Booting from the Flash

To start the NETBuilder II system from a flash memory card with preinstalled

Memory Card

software, follow the procedures in this section.

Prerequisites

Before you boot your new NETBuilder II system, you need to complete all setup

 

and installation instructions in the hardware guide provided with the system and

 

system components. You also need to connect a console to your system.

Booting an EZBuilt The EZBuilt NETBuilder II system comes with a factory-installed flash memory card NETBuilder II System that contain the NETBuilder software. To boot an EZBuilt NETBuilder II system,

follow these steps:

1Turn on the EZBuilt NETBuilder system.

The NETBuilder II system boots from the default boot source a:/primary/boot.29K (the flash memory drive).

2When the boot operation is complete, press the Return key on the console. The NETBuilder console prompt should appear on the screen.

If the console is not operating properly (if you see incorrect characters, or no characters), refer to the setup instructions in the hardware installation guide.

You are ready to establish basic settings on your system. Refer to Chapter 6 for more information.

Page 13
Image 13
3Com 09-1324-000 Installing Software and Booting DPE Netbuilder II System, Installing Software Performing Initial Boot