3Com 09-1324-000 manual Install System Software and Boot Refer to Chapter

Installation Checklists 1-3

NETBuilder II Systems Use the following checklist to install software, boot, and configure basic settings with a DPE Module on a NETBuilder II system with a DPE module.

Install System Software and Boot — Refer to Chapter 2.

❑Install software from a flash memory card.

Change the Primary Boot Source — Refer to Chapter 3

❑Change the primary boot source default as needed.

Configure Basic Settings — Refer to Chapter 6.

❑Log on to the system.

❑Familiarize yourself with the command-line or menu-driven user interface (UI), storing configuration parameter values, and getting help.

❑Obtain Network Manager privilege level.

❑Change the Network Manager password.

❑Adjust the time and date if necessary. Time and date are preset and may need to be adjusted for your time zone.

❑Set system administrator information:

❑System name and location

❑System contact name and phone number

❑Assign IP addresses/subnet masks to individual ports or one address to the system.

❑Set up the bridge/router for SNMP.

❑Set up NETBuilder II system security.

❑Use the Quick Installation Utility for further configuration.

Configure Specific Services for Your Network — Refer to Using NETBuilder

Family Software and Reference for NETBuilder Family Software.