Installing the Driver as Part of a New Server
Installation or Upgrade to NetWare 4.1x
This section has instructions for loading TLNKPODI.LAN as part of a new NetWare server installation or an upgrade to NetWare 4.1x. The procedure shows the essential steps for installing the server driver only. For most installations, other steps will be required; consult your Novell documentation for information about any procedures not described below.
1At the Load LAN Driver menu, insert TokenDisk diskette #1 into the drive and press Alt+Esc to switch from the Install program to the server console command prompt.
2Enter the following commands at the server console command prompt:
unload tokentsm unload msm
3From TokenDisk diskette #1, load the support modules required to run the server driver. Enter the following commands at the server console command prompt in the order shown:
load a:\netware\nwserver\4.1x\msm load a:\netware\nwserver\4.1x\tokentsm
Typically, the modules that ship with NetWare 4.1x are an earlier version than 2.50. It is recommended that you use MSM.NLM and TOKENTSM.NLM version 2.50 or later with
TLNKPODI.LAN.
4Press Alt+Esc to return to the Install program.
5Press Insert to load an unlisted LAN driver, and then follow the prompts to specify the driver load path.
6At the next menu, enter the following path: a:\netware\nwserver
After a short delay, a menu appears, showing the TLNKPODI.LAN driver.
7Press Enter to select the TLNKPODI.LAN driver.
8When asked if you want to copy the driver (to SYS:SYSTEM), respond Yes.
The next menu shows the parameters that can be used with the 3C359 token ring NIC driver.
