3Com TokenLink VelocityTM XL PCI Network Interface Card Unbind ipx tlnkpodi name Unload tlnkpodi

Installing a NetWare Server Driver 3-21

9Press Enter to view a list of supported options for the selected parameter.

Additional help for the parameter is also displayed in the lower text box. You can also find a description of parameters and explanations earlier in this chapter in “Using the Load Command.”

10After you have made selections for all 3C359 NIC driver parameters, press F10 to save the parameters and load TLNKPODI.LAN. Then follow the prompts to complete the server installation.

11After completing the installation, copy the support modules MSM.NLM and TOKENTSM.NLM from TokenDisk diskette #1 to the server’s SYS:SYSTEM directory.

Doing so causes the support modules to be auto-loaded by any of the server drivers, such as TLNKPODI.LAN. See “Copying Support Modules and the Driver to the

File Server” earlier in this chapter for instructions.

Unbind and Unload Commands You can use the Unbind or Unload commands to remove a driver (or logical board). The commands have the format shown below:

unbind ipx tlnkpodi <name>

unload tlnkpodi

The Unbind command requires only that you reenter the Bind command, and does not affect the Load command. You can selectively unbind a protocol for a particular logical board by specifying a board name, as shown in the command sample.

The Unload command completely unloads the driver from memory. If you wish to reload the driver, you will be required to use the Load and Bind commands.