3Com TokenLink VelocityTM XL PCI Network Interface Card manual Changing the DOS Test Setup

Using the Diagnostic Program 6-5

To run the tests continuously, select the Continuous option in the Test Setup dialog box, as described in the next section, “Changing the DOS Test Setup.”

Changing the DOS Test Setup

To change the test parameters, follow these steps:

1Select Test Setup in the Run Tests dialog box and press Enter.

The Test Setup dialog box appears, as shown in Figure 6-4.

Figure 6-4DOS Diagnostic Program Test Setup Dialog Box

2Press Tab to move from field to field and select any field within the Test Setup dialog box.

Within the Group Select area, use the arrow keys to select Group 1. (Future software enhancements will provide additional test groups.) Use the Enable Group or Disable Group options to enable or disable a group of tests.

For test descriptions, see “DOS Diagnostic Tests” earlier in this chapter.

3Select OK and press Enter.

4To run the tests, select Run Tests from the Test menu and select Start.