Accton Technology VS4512DC manual Setting the Switch’s IP Address, 146

Basic Configuration

Web – Click System, Bridge Extension.

CLI – Enter the following command.

Console#show bridge-ext 4-146

Max support vlan numbers: 255

Max support vlan ID: 4093

Extended multicast filtering services: No

Static entry individual port: Yes

VLAN learning: IVL

Configurable PVID tagging: Yes

Local VLAN capable: Yes

Traffic classes: Enabled

GMRP: Disabled

Console#

Setting the Switch’s IP Address

An IP address may be used for management access to the switch over your network. By default, the switch uses DHCP to assign IP settings to VLAN 1 on the switch. If you wish to manually configure IP settings, you need to change the switch’s user-specified defaults (IP address 0.0.0.0 and netmask 255.0.0.0) to values that are compatible with your network. You may also need to establish a default gateway between the switch and management stations that exist on another network segment.

You can manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server when it is powered on. Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods. Anything outside this format will not be accepted by the CLI program.

3-11