Configuring the Switch
Configuring IGMP Snooping and Query Parameters
You can configure the switch to forward multicast traffic intelligently. Based on the IGMP query and report messages, the switch forwards traffic only to the ports that request multicast traffic. This prevents the switch from broadcasting the traffic to all ports and possibly disrupting network performance.
Command Usage
•IGMP Snooping – This switch can passively snoop on IGMP Query and Report packets transferred between IP multicast routers/switches and IP multicast host groups to identify the IP multicast group members. It simply monitors the IGMP packets passing through it, picks out the group registration information, and configures the multicast filters accordingly.
•IGMP Querier – A router, or
Note: Multicast routers use this information, along with a multicast routing protocol such as DVMRP or PIM, to support IP multicasting across the Internet.
Command Attributes
•IGMP Status – When enabled, the switch will monitor network traffic to determine which hosts want to receive multicast traffic. This is also referred to as IGMP Snooping. (Default: Enabled)
•Act as IGMP Querier – When enabled, the switch can serve as the Querier, which is responsible for asking hosts if they want to receive multicast traffic. (Default: Enabled)
•IGMP Query Count – Sets the maximum number of queries issued for which there has been no response before the switch takes action to drop a client from the multicast group. (Range:
•IGMP Query Interval – Sets the frequency at which the switch sends IGMP
•IGMP Report Delay – Sets the time between receiving an IGMP Report for an IP multicast address on a port before the switch sends an IGMP Query out of that port and removes the entry from its list. (Range:
•IGMP Query Timeout – The time the switch waits after the previous querier stops before it considers the router port (i.e., the interface which had been receiving query packets) to have expired.
(Range:
•IGMP Version – Sets the protocol version for compatibility with other devices on the network. (Range:
Notes: 1. All systems on the subnet must support the same version.
2.Some attributes are only enabled for IGMPv2, including IGMP Report Delay and IGMP Query Timeout.