1: RDGS STORE
2: SAVED RDGS
3: ERROR
4: TEST
5: DISPLAY
6: BEEP
7: COMMA
8: REVISION
Enables or disables readin g memory.
Recalls readings stored in memory (up to 512 readings).
Retrieves errors from the error queue (up to 20 errors).
Performs a complete self-te st.
Enables or disables the front-panel display.
Enables or disables the be eper function.
Enables or disables a comma separator between digits on the display.
Displays the multimeter’s firmware revision codes.
1: HP-IB ADDR
2: INTERFACE
3: BAUD RATE
4: PARITY
5: LANGUAGE
Sets the GPIB bus address (0 to 31).
Selects the GPIB or RS-232 in terface.
Selects the baud rate for RS-232 opera tion.
Selects even, odd, or no pa rity for RS-232 operation.
Selects the interface lang uage: SCPI, Agilent 3478, or Fluke
8840/42.
1: SECURED
1: UNSECURED
2: CALIBRATE
3: CAL COUNT
4: MESSAGE
The multimeter is secured against calibration; enter code to unsecure.
The multimeter is unsecu red for calibration; en ter code to secure.
Performs complete calibration of present function; must be UNSECURED.
Reads the total number of times the multimeter h as been calibrated.
Reads the calibration string (up to 12 characters) entered from remote.
F: CALibration MENU* 1: SECURED > [ 1: UNSECURED ] > [ 2: CALIBRATE ] > 3: CAL COUNT > 4: MESSAGE
* The commands enclosed in square brackets ( [ ] ) are “hidden” unless the multimeter is UNSECURED for calibration.
D: SYStem MENU 1: RDGS STORE > 2: SAVED RDGS > 3: ERROR > 4: TEST > 5: DISPLAY > 6: BEEP > 7: COMMA > 8: REVISION
E: Input / Output MENU 1: GPIB ADDR > 2: INTERFACE > 3: BAUD RATE > 4: PARITY > 5: LANGUAGE
Chapter 2 Front-Panel Menu Operation Front-Panel Menu Reference 28