Agilent Technologies 34401A manual Execution Errors 350, 410, 420, 430

Chapter 5 Error Messages

Execution Errors

-350	Too many errors
	The error queue is full because more than 20 errors have occurred.
	No additional errors are stored until you remove errors from the queue.
	The error queue is cleared when power has been off, or after a *CLS
	(clear status) command has been executed.
-410	Query INTERRUPTED
	A command was received which sends data to the output buffer, but the
	output buffer contained data from a previous command (the previous
	data is not overwritten). The output buffer is cleared when power has
	been off, or after a *RST (reset) command has been executed.
-420	Query UNTERMINATED
	The multimeter was addressed to talk (i.e., to send data over the
	interface) but a command has not been received which sends data to the
	output buffer. For example, you may have executed a CONFigure
	command (which does not generate data) and then attempted an ENTER
	statement to read data from the remote interface.
-430	Query DEADLOCKED
	A command was received which generates too much data to fit in the
	output buffer and the input buffer is also full. Command execution
	continues but all data is lost.
-440	Query UNTERMINATED after indefinite response	5
	The *IDN? command must be the last query command within a

command string. Example: *IDN?;:SYST:VERS?

177