To Set the GPIB Address Each device on the GPIB (IEEE-488) interface must have a unique
address. You can set the multimeter’s address to any value between
0 and 31. The address is set to “22” when the multimeter is shipped from
the factory. The address is displayed on the front panel when you turn
on the multimeter. See also “GPIB Address,” on page 91.
1 Turn on the front-panel menu.
A: MEAS MENU
2 Move across to the I/O MENU choice on this level.
E: I/O MENU
3 Move down a level to the HP-IB ADDR command.
1: HP-IB ADDR
4 Move down to the “parameter” level to set the address.
Use the left/right and down/up arrow keys to change the addr ess.
∧22 ADDR
5 Save the change and turn off the menu.
The address is stored in non-volatile memory, and does not change when
power has been off or after a remote interface reset.
∨
< <
Shift <
On/Off
Auto/Man
ENTER
∨
4
Chapter 4 Remote Interface Reference
To Set the GPIB Address
161