Safety Symbol Definitions
Symbol | Description | Symbol | Description |
| Direct current |
| Terminal for Line conductor on permanently |
|
|
| installed equipment |
| Alternating current |
| Caution, risk of electric shock |
|
|
|
|
| Both direct and alternating current |
| Caution, hot surface |
|
|
|
|
|
| Caution (refer to accompanying documents) | |
|
|
|
|
| Earth (ground) terminal |
| In position of a |
|
|
|
|
| Protective earth (ground) terminal |
| Out position of a |
| (Intended for connection to external |
|
|
| protective conductor.) |
|
|
| Frame or chassis terminal |
| On (supply) |
|
|
|
|
| Terminal for Neutral conductor on |
| Off (supply) |
| permanently installed equipment |
|
|
| Terminal is at earth potential |
| Standby (supply) |
| (Used for measurement and control |
| Units with this symbol are not completely |
| circuits designed to be operated with |
| disconnected from ac mains when this switch is |
| one terminal at earth potential.) |
| off. To completely disconnect the unit from ac |
|
|
| mains, either disconnect the power cord or have |
|
|
| a qualified electrician install an external switch. |
Printing History
The edition and current revision of this manual are indicated below. Reprints of this manual containing minor corrections and updates may have the same printing date. Revised editions are identified by a new printing date. A revised edition incorporates all new or corrected material since the previous printing date. Changes to the manual occurring between revisions are covered by change sheets shipped with the manual. Also, if the serial number prefix of your power supply is higher than those listed on the title page of this manual, then it may or may not include a change sheet. That is because even though the higher serial number prefix indicates a design change, the change may not affect the content of the manual.
Edition 1 | June, 1991 |
Edition2 | September, 2000 |
© Copyright 1991, 2000 Agilent Technologies, Inc.
This document contains proprietary information protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated into another language without the prior consent of Agilent Technologies, Inc. The information contained in this document is subject to change without notice.
4
