Agilent Technologies 20ES, 20ET, 22ES, 22ET 8719ES, MODEL 8719ET Step 3. Perform and apply the appropriate error-correction. , Step 4. Measure the device under test.

1-5

Making Measurements

Making a Basic Measurement

Setting the Frequency Range

To set the center frequency to 134 MHz, press:

To set the span to 30 MHz, press:

NOTE You could also press the and keys and enter the frequency

range limits as start frequency and stop frequency values.

Setting the Source Power

To change the power level to −5 dBm, press:

NOTE You could also press and select

one of the power ranges to keep the power setting within the defined range.

Setting the Measurement

To change the number of measurement data points to 101, press:

To select the transmission measurement, press:

or on ET models:

To view the data trace, press:

Step 3. Perform and apply the appropriate error-correction.

Refer to the Chapter 5, “Optimizing Measurement Results,” for procedures on

correcting measurement errors.

To save the instrument state and error-correction in the analyzer internal memory,

press:

Step 4. Measure the device under test.

Replace any standard used for error-correction with the device under test.

To measure the insertion loss of the bandpass filter, press:

Center 134 M/µ

Span 30 M/µ

Start Stop

Power −5x1

POWER RANGE MAN

POWER RANGES

Sweep Setup

NUMBER OF POINTS

Meas

Trans: FWD S21 (B/R)

TRANSMISSN

Scale Ref

AUTOSCALE

Save/Recall

SELECT DISK

INTERNAL MEMORY

RETURN

SAVE STATE

Marker Search

SEARCH: MAX

Agilent Technologies Step 3. Perform and apply the appropriate error-correction. , Step 4. Measure the device under test.