Alliance Laundry Systems Supply Dispenser, Cycle Selection, Cycle Execution, Programming, Stardard Cycle Charts, NOTE: Press keys at their centers just hard enough to activate them

Supply Dispenser

Dry supplies are placed in the supply dispenser compartment cups prior to the start of each cycle.

Liquid supplies can be injected directly into the supply dispenser by an external chemical supply system.

NOTE: Supply dispenser compartment cups must not be removed when an external chemical injection supply system is attached to the washer- extractor.

Cycle Selection

NOTE: Press keys at their centers just hard enough to activate them.

Find the cycle number of the desired wash cycle from the Stardard Cycle Charts in the Programming section of this manual. Cycle numbers must be two- digit numbers from 01 to 39.

Press the numbers desired on the keyboard and note that these numbers are displayed after “NEXT”.

When keys are pressed on the keyboard, a beep will be heard. If an error is made, press the numbers again. As numbers are entered, they move from right to left on the display.

NOTE: If the 135-pound capacity washer-extractor is equipped with both steam and electric heat, the selector switch on the valve panel must be in the correct position for the desired heat source, down for steam heat, up for electric heat. (Electric heat is not available on the 250-pound capacity model.)

Cycle Execution

To start the selected cycle, press the Start key. If the selected cycle number is not in the computer memory, the display will show “NCYC”. If this happens, select another cycle. Otherwise, the display will now show the first step. For example, if the display reads “HL01”, “HL” represents a hot fill to low level, and “01” indicates that this is the first step of the cycle.

As the cycle proceeds, the display will show the function being executed, the step number, and the cycle number selected. Pressing the Edit Cycle key while the cycle is running will cause the display to show the remaining cycle time in minutes. Pressing this key again will return the display to normal.

Operation

To begin the cycle at any step other than the first step, press the Advance key to advance through the cycle to the desired starting point. (The Advance key is enabled at the factory and can be disabled at the laundry site.) Then press the Start key.

NOTE: Computer will not start in a spin step. It should be started in the drain step just prior to the spin.

It is possible to skip to the next step in a cycle, with the exception of a drain step: Drain steps must be allowed time to complete.

When the display shows the step desired to begin the cycle, press the Start key.

If the door is not locked, the display will indicate “CLOSE” and “DOOR”. If this occurs, be sure the door is closed and locked and press the Start key again.

If the LED indicator lights for the computer outputs indicate that one or more outputs are activated but the washer-extractor is not functioning according to the output or outputs indicated, contact a service technician.

As water fills the washer-extractor, one or more of the indicator lights located to the left of the keyboard will come on and stay on until the required water level is reached. LED dots located in the upper left corner of the last three digits on the right of the display will illuminate to indicate the water level(s) reached:

●When the indicator dot in the last digit on the right is lit, the low water level has been reached.

●When the dot in the next-to-the-last digit is lit, medium water level (optional) has been reached.

●When the dot over the third digit from the right has been lit, high level has been reached.

The cycle will continue until its completion. Then the display will show “DONE”.

F232101 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 27