Alliance Laundry Systems Programming, Programming Keypad, Low, Low, Hot, Hot, Cold, Cold, Fill, Warm, Warm, High, High, Wash, Wash, Heat, Heat, Over, Over, Soak, Soak, Clear, Clear

Programming

Programming Keypad

All sixteen keys are used in the Program Mode. Specific functions are printed in red on the keys. The Program Mode is active only when the Program Mode switch is in the PROGRAM position. (When programming is complete, remember to return the switch to the RUN position and remove the key.) Keys 1 – 6 and the Auxiliary/No Reverse key are dual

function keys in the Program Mode. In each instance (with the exception of the Warm/High key), when a key is first pressed in a programming step, the word printed at the top of the key applies. In most instances, the next time the same key is pressed – or if another key has been pressed in the interim, the word printed on the bottom of the key applies.

	Programming Keypad
Red Keys	Description
Cold	Cold is pressed when the step requires cold water.
Low	Low is pressed for low-level fill.
Hot	Hot is pressed when the step requires hot water.
Med./Fill	Med./Fill is pressed to select medium water level.
	Fill is pressed in the Manual Mode to operate fill valves.
Warm	Warm is pressed when the step requires warm water.
High	High is pressed for high-level fill.
Erase Cycle	Erase Cycle and a two-digit cycle code number are pressed to erase a cycle from memory.
Wash	Wash is pressed when the step is a wash or dilution rinse. Then key 1, 2, 3, 4, 6, or 7 is pressed to
	choose the type of agitation.
Heat	Heat is pressed when auxiliary heat is needed. This must be followed by a specific temperature
	selection, such as 165°F. The temperature must be entered; then a time assigned to reach that
	temperature must be entered.
Supply	Supply is pressed when soap, bleach, or other chemicals are desired. Key 1, 2, 3, 4, or 5 must then be
	pressed to indicate the specific supply dispenser being used. Combinations of these supplies can be
	programmed. Refer to Programming a Supply Step.
Over	Over is pressed when an overflow of water is desired. The drain is closed and water is added without
	regard to level. Water flows out the overflow connection for the time assigned to the step.
Add Cycle	Add Cycle is pressed to begin the process of programming a new cycle into memory.
Soak	Soak is used when no agitation is desired. This follows a fill and/or supply step. The time must be
	assigned in hours and minutes. (Wash 3 also provides no agitation.)
Medium Speed	Medium Speed is pressed when a medium spin only is desired for washing delicate items not suited for
	high-speed spin or when an intermediate spin is desired.
High Speed	High Speed is pressed when a fast spin is desired. Pressing the High Speed key once will activate the
	H1 spin; twice, the H2 spin; and three times, the H3 spin.
Edit Cycle	Edit Cycle is pressed followed by a two-digit cycle code number to display the steps of a
	preprogrammed cycle. The cycle may be altered during the edit cycle procedure by deleting, changing,
	or adding steps.
Add Step	Add Step is pressed to add a step to an existing cycle during the edit cycle procedure.
Clear (black on	Clear is pressed when an error has been made in programming a step. Instead of pressing Enter as the
red background)	step is completed, press Clear to eliminate the incorrect information. (Clear should never be pressed
	when displaying a cycle unless a particular step is to be eliminated or changed. Refer to Displaying a
	Cycle in Memory.)

F232101 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 35