Alliance Laundry Systems Cycle Programming, Displaying a Cycle in Memory, Displaying Individual Cycle Usage

Programming

Cycle Programming

Displaying a Cycle in Memory

1.Locate the key-operated programming switch:

●On 135-pound models, the Program Mode switch is located behind an access door directly below the emergency stop button (top right on the front panel of the washer- extractor).

●On 250-pound models, the Program Mode switch is located on the back side of the computer access door (left side of front panel of the washer-extractor) below the computer board.

Insert the key and turn the switch to the PROGRAM position. The display will read “CYC00”.

2.Press the Edit Cycle key on the keypad. The display will read “DCYC00”.

3.Press the two-digit code to display the desired cycle number: For example, press key 2 and then key 5 to select cycle 25. The display will read “DCYC25”.

4.Press the Enter key. The computer will search for cycle information for this cycle number.

If no cycle information exists, the computer will flash “NCYC25” followed by “ADD?”. To add this cycle, press the Enter key and proceed to the Add Cycle programming mode. If adding this cycle is not desired, press the Clear key, and the computer will then return to the normal programming mode.

5.If cycle information does exist for cycle 25, the computer will display “0425”, for example, to indicate that cycle 25 has been run four times. To clear the count (reset it to zero), press key 0. The display will then show “0025”.

If clearing the count is not necessary or if it has just been cleared, press the Enter key. The computer will now display “HH0125”, indicating the first step of cycle 25.

6.Press the Advance key to move to the next step of the cycle. To access further information pertaining to each step (for example, temperature and/or time), press the Enter key. If the display shows a temperature, press the Enter key again to display the time. Press the Enter key once more to advance to the next step.

7.At the end of the cycle, the computer will display “END-25” for two seconds and return to the normal programming mode.

8.Return the Program Mode switch to the RUN position and remove the key.

NOTE: Never press the Clear key while displaying a cycle in memory except to edit or delete a step.

Displaying Individual Cycle Usage

1.Locate the key-operated programming switch:

●On 135-pound models, the Program Mode switch is located behind an access door directly below the emergency stop button (top right on the front panel of the washer- extractor).

●On 250-pound models, the Program Mode switch is located on the back side of the computer access door (left side of front panel of the washer-extractor) below the computer board.

Insert the key and turn the switch to the PROGRAM position. The display will read “CYC00”.

2.Press the Edit Cycle key on the keypad. The display will read “DCYC00”.

3.Press the two-digit code to display the desired cycle number: For example, press key 2 and then key 5 to select cycle 25.

44 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232101