Programming

System Programming

Prompting the WE-6 allows:

●Displaying sump temperature in Centigrade or Fahrenheit.

●Recognizing and controlling one or two independent drains. (Two independent drains will apply only for special applications.)

●Enabling or disabling the Advance key in the Run Mode.

●Enabling or disabling the Manual Mode.

●Enabling or disabling wet clean functions (affects Auxiliary 1 and 2 outputs).

●Selecting balance routine (active if inverter balance detection is utilized).

●Reading or resetting the cycle count.

To prompt the computer:

1.Locate the key-operated programming switch:

●On 135-pound models, the Program Mode switch is located behind an access door directly below the emergency stop button (top right on the front panel of the washer- extractor).

●On 250-pound models, the Program Mode switch is located on the back side of the computer access door (left side of front panel of the washer-extractor) below the computer board.

Insert the key and turn the switch to the PROGRAM position. The display will read “CYC00”.

2.Press the Auxiliary key, key 2, and key 9 in that order. The display will read either “CEN” (Centigrade) or “FAR” (Fahrenheit). To choose the alternate feature, press key 0.

3.Press the Enter key. The display will read either “1DRAIN” or “2DRAIN”. The normal prompt for most applications is “1DRAIN”. “2DRAIN” is used only for special applications. Consult factory for full details. To choose the alternate feature, press key 0.

4.Press the Enter key. The display will read either “ADV” or “NO-ADV”. The prompt “NO-ADV” will disable the Advance key in the Run Mode, thereby preventing the operator from advancing the computer through steps of the cycle before they are complete; also it will not be possible to advance to any step before starting a cycle if “NO-ADV” is selected. To choose the alternate feature, press key 0.

5.Press the Enter key. The display will read either “MANUAL” or “NO-MAN”. If “MANUAL” is displayed, the Manual Mode will be enabled during normal operation. If “NO-MAN” is displayed, the Manual Mode will be disabled when a cycle is run, even if the Manual operation key sequence is entered. To choose the alternate feature, press key 0.

6.Press the Enter key. The display will read either “WET CL” or “NO WCL”. To choose the alternate feature, press key 0. If “WET CL” is displayed, wet clean functions are enabled. If “NO WCL” is displayed, wet clean functions are disabled.

42

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232101