Alliance Laundry Systems Editing a Cycle

4.Press the Enter key. The display will show

“xx25”. (The “xx” here stands for the number of times cycle 25 has been run and will be represented by numbers in the actual display.)

The computer will remain in this step until one of the following options has been chosen:

●Press the Enter key to continue displaying the cycle, OR

●Press the Clear key to return to the normal programming mode, OR

●Press key 0 to reset the counter for this cycle to zero, OR

●Take the computer out of the Program Mode.

Editing a Cycle

To edit a cycle in memory or to change, add, or delete

astep:

1.Locate the key-operated programming switch:

●On 135-pound models, the Program Mode switch is located behind an access door directly below the emergency stop button (top right on the front panel of the washer-extractor).

●On 250-pound models, the Program Mode switch is located on the back side of the computer access door (left side of front panel of the washer-extractor) below the computer board.

Insert the key and turn the switch to the PROGRAM position. The display will read “CYC00”.

2.Press the Edit Cycle key on the keypad. The display will read “DCYC00”.

3.Press the two-digit code for the cycle requiring editing. For example, press key 2 and then key 5 to select cycle 25.

Programming

4.Press the Enter key. The computer will search for cycle information for this cycle.

If no cycle information exists, the computer will flash “NCYC25” followed by “ADD?”. To add this cycle, press the Enter key and proceed to the Add Cycle programming mode. If adding this cycle is not desired, press the Clear key. The computer will then return to the normal programming mode.

5.If cycle information does exist for cycle 25, the computer will display “0425”, for example, to indicate that cycle 25 has been run four times. To clear the count (reset it to zero), press key 0. The display will then show “0025”.

If clearing the count is not necessary or if it has just been cleared, press the Enter key. The computer will now display “HH0125”, indicating the first step of cycle 25.

6.Press the Advance key to move to the next step of the cycle.

7.Press key 0 to back up to the previous step.

8.To access further information pertaining to each step (for example, temperature and/or time), press the Enter key.

If the display shows a temperature, press the Enter key again to display the time.

9.Press the Enter key once more to advance to the next step.

10.At any time, the programmer can put the Program Mode switch in the RUN position, and the computer will return to normal running mode, provided all pertinent data for the last step edited is entered.

F232101 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 45