Alliance Laundry Systems Test Cycle, Wet Clean Testing

Operation

Test Cycle

Cycle number 01 is a test cycle used to analyze washer-extractor functions. Refer to the Programming section of this manual.

Step 01 in cycle number 01 is a cold fill to low level. This step is designed to give not quite enough time to complete a fill, causing the display to read “FILL”.

Press the Start key to continue the fill, and the test cycle will proceed.

Step 02 in the test cycle is a drain step. Again, the time allotted is shorter than it would be in a normal cycle. The display will read “EMTY”. To proceed, press the Start key.

The steps in the test cycle are relatively short, with the exception of steps 03, 21, 25, 27, 28, and 29. These can be shortened by pressing the Advance key to go on to the next step.

The operator may skip to any next step in the cycle with the exception of a drain step; drain steps must be allowed to complete. To skip forward in the test cycle, press the Advance key.

Wet Clean Testing

Wet clean processing outputs are tested through the energizing of the Auxiliary 1 output in step 18 and Auxiliary 2 output in step 19. Steps 30 through 33 are designed to test water reuse processing, if this option is installed. If it is not, the outputs associated with each step will be energized, and the cycle will conclude normally.

NOTE: Prompts for “1DRAIN” and “WET CL” must be selected when prompting the WE-6 microcomputer in order for steps 18 and 19 to work properly for wet clean processing.

NOTE: The Advance feature may be disabled. Refer to Prompting the WE-6 in the Programming section of the manual.

28 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232101