Alliance Laundry Systems manual only

Programming

27.The next step is to program a high-speed 1 spin, the lowest of three high speeds. (Pressing the High Speed key repeatedly when programming a high-speed step will cause the computer display to proceed from “H1” to “H2” and then to “H3”, the maximum-speed spin. After “H3” appears and the High Speed key is pressed again, “H1” will reappear.)

a.Press the High Speed key once. The display will read “H11239”.

b.Press the Enter key. The display will read “M---S”.

c.Enter a length of time for the high-speed spin (six minutes). Press key 6. The display will read “6M-00S”.

NOTE: High-speed spin is not preceded automatically by medium-speed spin. Medium- speed spin only or high-speed spin 1, 2, or 3 may be programmed.

28.Press the Enter key. The display will flash

“SDLY” for one second. (“SDLY” also displays during the entire actual coastdown.) The display will then read “0M-00S”, inviting the programmer to enter a time for the slow-down delay (coast). If the application requires that the basket coast before it stops, enter the desired coast time (30 seconds here) and press the Enter key. If no coast is desired, press the Enter key only. The display will read “1339”.

NOTE: A slow-down delay of 30 seconds minimum should be programmed after each high-speed spin if the speed is not followed by a higher speed spin or another spin at the same speed. Longer motor and belt life are direct benefits. All the preprogrammed and optional cycles in this manual reflect this practice.

29.The previous step ends the tutorial. Cycle 39, consisting of 12 steps, has been completely programmed.

To end the cycle, turn the Program Mode switch located on the left side of the control module to the RUN position and remove the key. The display will then read “NEXT”.

The programmer can now select Cycle 39 and press the Enter key to run the cycle, if desired; or a cycle of the programmer’s own design can be programmed.

Tutorial Cycle

Step	Description	Min:sec
1	Hot Fill to Low Level	4:00
2	Supply 1	0:30
3	Wash 1	6:00
4	Drain 1	1:00
5	Cold Fill to High Level	5:00
6	Wash 1	3:00
7	Drain 1	1:00
8	Cold Fill to High Level	5:00
9	Wash 1	3:00
10	Drain 1	1:00
11	Medium Speed Spin	1:00
	SDLY	0:00
12	High Speed Spin No. 1	6:00
	SDLY	0:30
	Stop Routine
	Table 3

40 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT F232101