Alliance Laundry Systems Transferring All Cycles from Computer to Simulator, Transferring One Cycle from Computer to Simulator

Transferring All Cycles from Computer to Simulator

All keypad commands will be entered with the simulator keypad.

Use the following procedure to transfer all cycles contained in the memory of the computer to the simulator. (Transferring 39 cycles takes about

6seconds.)

1.Connect the fiber optic cables between the simulator and the computer. Verify that the colored plugs on the ends of the optic cables match the colors of the ports on the simulator and on the washer-extractor’s control module (gray to gray, blue to blue).

2.Place both the simulator and the computer in the Program Mode. The display on both will read “CYC00”.

3.Press key 0. The display will read “WRITE?”.

4.Press key 0 again. The display will change to “READ?”.

5.Press the Enter key. The display will read “ALL”.

6.Press the Enter key again. The simulator display will flash “RECV” and “ALL” alternately. The computer display will flash “SEND” and “ALL” alternately.

When the two displays stop flashing, the transfer is complete.

Programming

Transferring One Cycle from Computer to Simulator

All keypad commands will be entered with the simulator keypad.

Use the following procedure to transfer one cycle contained in the memory of the computer to the simulator. (Transferring 1 cycle takes less than

1second.)

1.Connect the fiber optic cables between the simulator and the computer. Verify that the colored plugs on the ends of the optic cables match the colors of the ports on the simulator and on the washer-extractor’s control module (gray to gray, blue to blue).

2.Place both the simulator and the computer in the Program Mode. The display on both will read “CYC00”.

3.Press key 0. The display will read “WRITE?”.

4.Press key 0 again. The display will change to “READ?”.

5.Press the Enter key. The display will read “ALL”.

6.Press key 0. The display will read “CYC”.

7.Press the Enter key. The display will read “RCYC00”.

Now press the 2-digit code for the desired cycle number from the computer.

8.Press the Enter key. The display will read “WCYCcc”.

Now press the 2-digit code for the desired cycle number under which the cycle should be saved in the simulator.

9.Press the Enter key. The simulator display will flash “RECV” and “CYC” alternately. The computer display will flash “SEND” and “CYC” alternately.

When the two displays stop flashing, the transfer is complete.

F232101 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 59