Programming Tutorial

The following procedure guides the programmer through a complete cycle and allows hands-on experience for programming cycles. The complete cycle is listed in Table 3.

1.Locate the key-operated programming switch:

●On 135-pound models, the Program Mode switch is located behind an access door directly below the emergency stop button (top right on the front panel of the washer- extractor).

●On 250-pound models, the Program Mode switch is located on the back side of the computer access door (left side of front panel of the washer-extractor) below the computer board.

Insert the key and turn the switch to PROGRAM position. The display will read “CYC00”.

2.Press the Add Cycle key. The display will read “ACYC00”.

3.A two-digit number from 01 to 39 must be entered. Cycle number 39 is recommended because standard program versions use this short cycle for performing a chemical supply setup.

4.Press key 3, then key 9, then the Enter key. The display will read “CYC39”.

a.If the display alternately flashes “EXISTS” and “EDIT?”, press the Clear/Stop key. The display will return to “CYC39”.

b.Erase the existing cycle: Press the Erase Cycle key. The display will show “ECYC39”. Press key 3, then key 9, then the Enter key. The display will read “WAIT” briefly and then “CYC39”.

c.Press the Add Cycle key. The display will read “ACYC39”. Press key 3, then key 9, then the Enter key. The display will show “0139”.

Programming

5.Enter the desired function for step 1. A natural choice might be hot fill to low level.

a.Press the Hot key and then the Low key. The display will read “HL0139”.

b.Press the Enter key. The display will read “M---S”.

c.Now enter the desired fill time. The recommended number of minutes is four. Press key 4. The display will read “4M-00S”.

6.Now press the Enter key. The display will read “0239”, indicating that the computer is ready for step 2 of cycle 39.

7.A natural choice for step 2 is the addition of a supply.

a.To add supply No. 1, press the Supply key and then key 1. The display will read “S10239”.

b.Press the Enter key and the display will read “M---S”.

c.Now enter the desired time in minutes and seconds for the supply valve to be turned on. Thirty seconds is the recommended time.

Press key 0 for minutes, and the display will read “0M-00S”.

Now press key 3 and then key 0. The display will read “0M-30S”, indicating a supply time of thirty seconds.

8.Now press the Enter key. The display will change to read “0339”, indicating that the computer is ready for step 3.

F232101

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

37