17.Now program a drain step:

a.Press the Drain key. The display will read

“D-0739”. Then press key 1. The display will read “D10739”.

b.Press the Enter key. The display will now read “M---S”.

c.Enter the length of time the computer will allow the machine to drain (one minute).

Press key 1. The display will read “1M-00S”, indicating that a one-minute step has been programmed.

18.Press the Enter key. The display will read “0839”.

19.Program a cold fill to high level:

a.Press the Cold key and the High key. The display will read “CH0839”.

b.Press the Enter key. The display will read “M---S”.

c.Enter the maximum time to allow for the fill. In this case, five minutes is sufficient. Press key 5. The display will read “5M-00S”.

20.Press the Enter key as always after programming a time duration. The display will read “0939”, indicating that the computer is ready for step 9.

21.For step 9, program the agitation action for another dilution rinse.

a.Press the Wash key and key 1 to program an action with normal reversing. The display will read “W10939”.

b.Press the Enter key. The display will read “M---S”.

c.Enter the time for the dilution rinse (three minutes).

Press key 3. The display will read “3M-00S”.

22.Press the Enter key. The display will read

“1039”, indicating that the computer is ready for step 10.

Programming

23.The dilution rinse water must be drained once again.

a.Press the Drain key. The display will read

“D-1039”. Then press key 1. The display will read “D10739”.

b.Press the Enter key. The display will read “M---S”.

c.Enter the length of time the computer will allow the machine to drain (one minute).

Press key 1. The display will read “1M-00S”, indicating that a one-minute step has been programmed.

24.Press the Enter key to move to step 11 of the cycle. The display will read “1139”.

25.An extract step should now be programmed.

a.Press the Medium Speed key. The display will read “MS1139”, indicating a medium-speed spin.

b.Press the Enter key. The display will read “M---S”.

c.Enter the length of time for the medium-speed spin (one minute).

Press key 1. The display will read “1M-00S”.

26.Press the Enter key. The display flashes “SDLY” for one second. It will then read “0M-00S”, allowing the programmer to enter the time for a slow-down delay (coast).

In a later step – to have the basket coast before it stops, enter the desired coast time (up to

99 seconds). However, do not enter a time now. That would cause a coast before a higher spin speed (which will be the next step).

For no coast, press the Enter key.

F232101

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

39