To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
Disassembly Procedures
19 RS3100007 Rev. 0
WARNING
!
Pressure Switch
1. Loosen control hood assembly, see “Control Hood
Assembly” procedure steps 1 and 2.
2. Disconnect wires and plastic hose from pressure
switch.
3. Remove screws securing pressure switch to control
hood mounting plate.
4. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when rewiring
components.
NOTE: Before connecting hose to pressure switch,
blow air through pressure hose to remove any
condensation that may have accumulated in the
hose.
Rocker Switch
1. Loosen control hood assembly, see “Control Hood
Assembly” procedure steps 1 and 2.
2. Disconnect wire terminals from switch.
3. Squeeze plastic tabs located on top and bottom of
switch and push switch out through the front of
control panel.
4. Reverse procedure to reassemble.
Graphic Panel
1. Remove all knobs from switches.
2. Loosen control hood assembly, see “Control Hood
Assembly” procedure steps 1 and 2.
3. Disconnect wires from components and carefully
remove components from control hood assembly,
see component removal procedure listed earlier.
4. Remove screws securing top cover to control
mounting plate and remove top cover.
5. Remove screws securing end panels (each side) and
remove end panels.
6. Remove grounding clip secured to metal tab on
graphic panel.
7. Bend tabs on graphic panel (located inside of control
hood) straight out towards the rear.
8. Remove graphic panel from front of control mounting
plate.
9. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when rewiring
components.
Loading Door
1. Open loading door.
2. Remove screws securing left hinge to door and
remove hinge.
Loading
door
Hinge
attaching
screws
Hinge
attaching
screws
Hinge
(right side)
Hinge
(left side)
3. Raise loading door to a vertical position, disengage
loading door from loading door clip by swing left side
of door toward front of washer.
Loading
door
4. Rotate loading door so door is upside down.