Amana RS3100007 Observe all local codes and ordinances, Siphon Break Kit, Drain Hose Extension

Important Safety Information

About Ground Wires

In the event of an electrical short circuit, a ground wire reduces the risk of electric shock by providing an escape wire for the electric current.

Standard accepted color coding for ground wires is green or green with a yellow

stripe.

Grounding Instructions

For safety, washer must be grounded. All washer power supply cords are equipped with 3-prong grounding plug. Plug on cord must be plugged into appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not modify plug on washer cord. If plug will not fit outlet, have qualified electrician install proper outlet.

!WARNING

To avoid risk of personal injury or death due to electrical shock:

Grounding wires and wires colored like grounding wires are NOT to be used as current carrying conductors.

Save These Instructions

•Observe all local codes and ordinances.

•Disconnect electrical power to unit before servicing.

•Ground appliance properly.

•Check with a qualified electrician if you are not sure this appliance is properly grounded.

•DO NOT ground to gas line.

•DO NOT ground to cold water pipe if pipe is interrupted by plastic, non-metallic gaskets, or other insulating (non- conducting) materials.

•DO NOT modify plug on power cord. If plug does not fit electrical outlet, have proper outlet installed by qualified electrician.

•DO NOT have a fuse in the neutral or ground circuit. A fuse in the neutral or ground circuit could result in an electrical shock.

•DO NOT use an extension cord with this appliance.

•DO NOT use an adapter plug with this appliance.

•DO NOT pinch power cord.

Washer Dimensions

			53.5"
			(137.1cm)
36.6" (93 cm)			cm)
	H C		43.6" (110.7
	26.9" (68.3 cm)		28" (71.1 cm)
			2"
			(5.1 cm)
RS3100007		Rev. 0	A–6

Optional Kits

Kits are available at extra cost through Amana dealer or Amana factory 1-800-843-0304.

Siphon Break Kit

For standpipe installation below 36" (91.44 cm), install part #562P3.

Longer Water Inlet Hoses

8’ (2.44 m) inlet hose, part #20617. 10’ (3.05 m) inlet hose, part #20618.

Drain Hose Extension

Order this kit in two parts: the coupler, part #406P3, and 1' additional drain hose, part #20616.

Anchor Kit

To stop washer from moving on uneven surfaces, install part #155P3.

Adjustable leg Extension Kit

To level washer on extremely uneven surfaces, install part #566P3.