Disassembly Procedures |
|
| ||
! | WARNING | To avoid risk of electrical shock, personal injury, or | ||
death, disconnect power to unit before servicing. | ||||
|
| NOTE: Hooks must be positioned 180° from each other, | ||
|
| and must be placed under base of agitator near | ||
|
| agitator vane for greater stability. If hooks are | ||
Loading |
| placed between the vane area, agitator damage | ||
door |
| may occur. |
| |
|
| 3. Using a rocking motion | ||
|
| agitator up off drive bell. |
| |
|
| 4. To reassemble place agitator on top of drive bell. | ||
|
| Slowly rotate agitator until fingers on underside of | ||
|
| agitator line up with large slots on drive bell. | ||
|
| 5. A sharp blow on top of agitator, with the palm of your | ||
|
| hand, will force agitator down onto drive bell, | ||
|
| allowing fingers on underside of agitator to lock | ||
|
| under bottom edge of drive bell. |
| |
5. Maneuver loading door from washer cabinet top. | NOTE: Do not push agitator onto drive bell any further | |||
|
| than necessary. |
| |
Loading |
|
|
| |
door |
| Agitator, Drive Bell and Seal Assembly | ||
|
| |||
|
| NOTE: If water is present in washtub, remove water | ||
|
| before attempting to remove drive bell. | ||
|
| 1. Remove agitator, see “Agitator” procedure. | ||
|
| 2. Remove plug and 7/16" bolt from top of drive bell. | ||
|
| 3. Using care pry drive bell upward off transmission | ||
|
| shaft. |
| |
|
| 4. Remove old seal from hub assembly by: | ||
|
| a. Placing a flat bladed screwdriver between bottom | ||
|
| edge of seal and hub. |
| |
|
| b. Using washtub bolts as a pry area, pop off lower | ||
6. Remove screws securing right hinge and remove | seal bead. |
| ||
c. Grasping bottom of seal and pulling straight up | ||||
loading door. |
| |||
| freeing upper seal bead. |
| ||
7. Reverse procedure to reassemble. |
| |||
|
| |||
|
| Hex |
| |
Agitator |
| nut | Transmission | |
1. Open loading door. |
|
| output shaft | |
2. Remove agitator by placing hands under agitator lip | Hub |
| ||
and pull upward, if agitator is stuck or stubborn use | assembly | Washer | ||
two agitator hooks, No. 254P4P, under bottom edge |
| |||
|
| |||
of agitator. |
|
|
| |
| Agitator |
|
| |
| hooks |
|
| |
|
| Hub | Bronze | |
|
| shoulder | bearing | |
5. Clean all foreign material from seal mounting area of hub assembly, bronze bearing and washer.
6. Lubricate new seal with liquid soap or soapy water to aid in assembly of seal onto hub.
RS3100007 Rev. 0 | 20 |
