Amana RS3100007 Dispensers, Clean softener dispenser after each use. Remove dispenser

Dispensers

Bleach Dispenser

Bleach dispenser is located in left front corner under loading door.

Bleach dispenser

Use only liquid bleach in dispenser. To use powdered bleach, add to wash tub with detergent.

Carefully and slowly, pour recommended amount of bleach into dispenser during first washer fill. See table.

Be careful not to spill undiluted bleach. It is a strong chemical and can damage cabinet finishes and some fabrics if not properly diluted. Follow bleach manufacturer’s label for proper use.

LO AD SIZE	BLEACH
	(M ax Am t.)
SUPER PLUS	1 cup
LARGE	1 cup
MEDIUM	3/4 cup
SMALL	1/2 cup

Fabric Softener Dispenser

Fabric softener dispenser is located on top of agitator. Dispenser automatically releases liquid fabric softener at proper time during rinse cycle.

Fabric softener dispenser

Fabric Softener Use Tips

•Liquid fabric softeners are dispensed during final rinse. Do not combine with bleach, bluing, starch, detergents, soaps, or packaged water conditioners during rinse.

•Do not use fabric softener in dispenser during DOUBLE WASH cycle.

•Do not mix powdered detergent with liquid softener in dispenser or softener will become gummy.

To use dispenser, follow these steps:

1.Pour liquid fabric softener into dispenser, using amount recommended on package.

2.Add water up to fill level, but do not exceed tip of fill arrow indicator.

FABRIC SOFTENER MUST BE DILUTED FOR USE.

•Do not stop washer during first spin or dispenser will empty too soon.

•Never pour fabric softener directly onto clothes or spots and stains may result. To remove softener stains, soak in soapy solution of Sard™ Wonder Soap or Ivory™ soap, or rub stain with bar of Sard™ or Ivory™ soap and wash garment as usual.

•For best softener performance, set water level to medium or higher.

3.Clean softener dispenser after each use. Remove dispenser

housing from agitator by squeezing lower part of dispenser and pulling up on housing while tilting slightly to expose dispenser cup. Rinse dispenser housing and cup in hot soapy water.

Clean funnel shape in top of

agitator and inside of agitator. Use small brush on hole and slots in two funnel rings for thorough cleaning.

After cleaning, re-install dispenser cup. Push dispenser housing directly down onto top of agitator until firmly snapped together.

To prevent build-up, fill dispenser with clean water in wash cycles when not using softener.

RS3100007 Rev. 0 B–8