Installation Instructions

5 POSITIONWASHER AND LEVEL

Position washer in final location on clean, dry, firm, and level floor.

NOTE: To avoid damage to legs and base, do not slide washer across floor if leveling legs have been extended.

1.Loosen 7/8" locknuts and extend front leveling legs. Place rubber foot pads on all four leveling legs. Adjust front 2 leveling legs until machine is level side-to-side. Be sure machine does not rock. Tighten locknuts up to washer base, or washer will move out of position during operation.

2.Once front legs are adjusted, gently tilt washer forward on front legs and lower into place to correctly set rear self-leveling legs.

Check that washer is level front-to-back and side-to-side.

WASHER MUST NOT ROCK.

1. Level Front Legs

Lock nut

 

Rubber

Leveling

foot

foot

pad

2. Level Rear Legs

6CONNECT POWER CORD TO ELECTRICITY

See Installation Requirements section. Plug washer into

3-prong grounded outlet only.

Questions? See Owner’s Manual or call Amana Consumer Affairs

7CLEAN TUB AND RUN THROUGH ONE WASH CYCLE WITHOUT CLOTHES

Wipe tub with clean rag and soap diluted in warm water to remove any oil used in manufacturing. Use household spray cleaner if necessary.

Add water and detergent to washtub, and run before first use.

Department

1-800-843-0304

RS3100007 Rev. 0

A–4

Page 33
Image 33
Amana RS3100007 service manual Positionwasher and Level, Prong grounded outlet only