Amana RS3100007 service manual Installation Instructions

Installation

Instructions

Top Loading Washer

Keep instructions for future reference. Be sure manual stays with washer.

1MOVE WASHER TO FINAL AREA; REMOVE SHIPPING BRACE

& PLUG

Protect the floor when moving the washer. Washer must be within 4 feet of desired area before beginning installation. Open washer lid and remove installation parts from shipping brace for use.

Reach through foam shipping brace, grasp bottom of brace, and pull up to remove.

NOTE: Save shipping plug and shipping brace; reinstall whenever washer is moved more than 4 feet.

Do not lift or move washer without shipping materials in place.

To remove the shipping plug from the washer, step on the card board base, tilt the washer back, and slide out the base.

	Shipping
	brace
	Shipping
Cardboard	plug
base

2CONNECT WATER FILL HOSES TO

WASHER

Tightly push one flat rubber washer into one end of each water fill hose and attach this end of hose to washer. HOT and COLD connections are identified by letters H and C stamped into washer cabinet and by HOT and COLD printed on water fill hoses.

In most cases, hoses should cross when attached to correct water temperature faucet.

Tighten hose connections by hand until snug, then another ¼ turn with pliers. DO NOT cross-thread or over- tighten couplings.

H C

HOT

COLD

Push rubber washer

into end of fill hose.

RS3100007 Rev. 0 A–2