Removing the Installed AirPort Card
1.Pull back on the antenna clip (Figure 7A) to release the antenna cable connector (Figure 7B) and allow the card to rise up slightly.
2.Pull the card from the AirPort connector (Figure 7D).
3.If there is tape securing the antenna cable to the AirPort Card, carefully remove it and store it in the battery compartment for reuse later. When installing the replacement AirPort Card, use the tape to secure the cable in the same manner.
4.To disconnect the antenna cable connector, hold the AirPort Card with one hand and grasp the antenna cable connector with the other. While being careful not to strain the antenna cable (Figure 7C), firmly pull the connector straight out of the AirPort Card.
Figure 7
D
C
A
B
Important: If reassembling the computer without an AirPort Card, replace the antenna cable connector into its holder (Figure 9B) and pull the loop of the antenna cable up slightly and away from the edge of the computer case. This prevents the cable from interfering with the PC card slot, below, or getting pinched during reassembly.
Also, if the AirPort Card connector (Figure 7D) is rotated up, push it down into the level position. This allows the bottom case to install properly.
PowerBook G4 (1GHz/867MHz) AirPort Card- 5
