Appendix J
In case of difficulty
• If you are using the speakerphone, eliminate any background noise. Noise from a television, radio,
| or other appliances may cause the telephone to |
| not dial out properly. If you cannot eliminate the |
| background noise, first try muting the telephone |
| before dialing, or dialing from another room in |
| your home with less background noise. |
|
|
I cannot page or make | • Make sure you dialed the extension correctly. |
intercom calls. | • Make sure Line 1 is connected and has the same |
| phone number on all system phones. |
| • The destination telephone may be on an external |
| call. Wait and try again. |
| • Make sure the Do Not Disturb function is turned |
| off on the destination system telephone (page 15). |
| • Make sure the [INTERCOM] light is off before you |
| making a page or Intercom call. If the light is on, |
| the system is busy or the intercom is unavailable. |
| Try again when the intercom light goes out. |
| • Make sure the telephone line cord connected to |
| line jack L1/L2 was provided with the telephone. |
| • Check to make sure that each telephone set |
| has a unique extension number. If the sets |
| receive AC power at the same time, either |
| at initial installation or after a power failure, the |
| extension numbers may be the same. Refer |
| to the EXTENSION NUMBER section of the |
| installation guide, (page 32). |
I cannot transfer outside calls.
•If you are on a conference call with another telephone in the same system (page 22), the call cannot be transferred.
•If the destination telephone is on an outside call or intercom call with another system telephone, the call cannot be transferred.
•All extensions must have the same outside telephone line connected to Line 1.
•Make sure the telephone line cord connected to line jack L1/L2 was provided with the telephone.
•Make sure that the LINE GROUP assignment is correct. See page 43.
102