Instruction book

2.By pressing the ↓ key, a number of actually measured data can be found (see Fig. 8.1).

3.If one of the sensors is linked to a shut-down, service or warning function, both the actually measured value as well as the corresponding shut-down, warning or service level can be called up by pressing the tabulator key (5).

8.5 Counters menu

Function

To allow the operator to call up the:

-running hours

-regulator (module) hours (the hours the module has been under tension)

-running hours per compressor module

-starts per compressor module

-shutdowns per compressor module

Procedure

1.Starting from the Main screen (see section 8.1.2):

-press the key "Menu" (F1)

-press the ↓ key until the option "Counters" is followed by a horizontal arrow

-press the tabulator key (5) to activate the menu

2.By pressing the ↓ key, the above-mentioned data can be found (see also Fig. 8.1).

8.6 Test menu

Function

To carry out a display test, i.e. to check whether the display and LEDs are still intact.

Procedure

1.Starting from the Main screen (see section 8.1.2):

-press the key "Menu" (F1)

-press the ↓ key until the option "Test" is followed by a horizontal arrow

-press the tabulator key (5) to activate the menu

2.The option "Display test" will be followed by a horizontal arrow.

3.After pressing the tabulator key (5), the regulator will generate a series of patterns on the display which enable the operator to check that each pixel still functions normally; at the same time the LEDs are lit.

2920 1521 00

48

Page 48
Image 48
Atlas Air Compressor manual Counters menu, Test menu