Appendix B
CE Guidelines
CE Declaration of Conformity
Baldor indicates that the products are only components and not ready for immediate or instant use within the meaning of “Safety law of appliance”, “EMC Law” or “Machine directive”.
The final mode of operation is defined only after installation into the user’s equipment. It is the responsibility of the user to verify compliance.
The product conforms with the following standards:
DIN VDE 0160 / 05.88 | Electronic equipment for use in |
| electrical power installations |
DIN VDE 0100 | Erection of power installations with |
| nominal voltages up to 1000V |
DIN IEC 326 Teil 1 / 10.90 | Design and use of printed boards |
DIN VDE 0110Teil | Dimensioning of clearance and |
| creepage |
DIN VDE 0110Teil 20 / 08.90 | distances |
EN 60529 / 10.91 | Degrees of protection provided by |
| enclosures |
EMC – Conformity and CE – Marking
The information contained herein is for your guidance only and does not guarantee that the installation will meet the requirements of the council directive 89/336/EEC.
The purpose of the EEC directives is to state a minimum technical requirement common to all the member states within the European Union. In turn, these minimum technical requirements are intended to enhance the levels of safety both directly and indirectly.
Council directive 89/336/EEC relating to Electro Magnetic Compliance (EMC) indicates that it is the responsibility of the system integrator to ensure that the entire system complies with all relative directives at the time of installing into service.
Motors and controls are used as components of a system, per the EMC directive. Hence all components, installation of the components, interconnection between components, and shielding and grounding of the system as a whole determines EMC compliance.
The CE mark does not inform the purchaser which directive the product complies with. It rests upon the manufacturer or his authorized representative to ensure the item in question complies fully with all the relative directives in force at the time of installing into service, in the same way as the system integrator previously mentioned. Remember, it is the instructions of installation and use, coupled with the product, that comply with the directive.
Wiring of Shielded (Screened) Cables
Remove the outer insulation | Conductive |
to expose the overall screen. | Clamp |
| <30mm |
<30mm 500mm max. |
|
MN735 | CE Guidelines |
