5. Source Selection
Image5-2
The Barco logo on the menu indicates the presence of a signal, the digit indicates the shortcut key on the
RCU.
The3 first sources (Data on BNC’s, Component Video & RG(s)B) refer to the 5-cable input, the p osition of the
indication “1” will always show which BNC configuration is selected.

When to select “Data on BNC’s”

SelectD ataon BNC’s when a data signal is connected to the BNC’s

When to select “Component video” ?

SelectComponent video when a video signal of the type (R-Y/Y/B-Y) is connected on the BNC’s.

When to select RGsBVideo?

SelectRG sB Video when an RGB video signal (15 KhZ) with Sync on green or sync on H is presented on the BNC’s.
Thissignal is routed to the video circuit and is projected in a Video Window.
5.2 Composite Video

How to select one of the 7 composite video inputs ?

1. Press MENU to activate the Tool bar
2. Press ↓to Pull down the Source Selection menu
3. Use ↑or ↓to select Composite video
4. Press →to Pull down the submenu
5. Use ↑or ↓to select one of the different video inputs (image 5-3)
Note: Video2is an optional Video input and is only displayed in case the optional Video/Audio layer is installed.
If the extended mode is disabled, the submenu contains only 1 selection (2 selections if the Audio & Video option is
installed).
6. Press ENTER to confirm your choice
Awhite bullet indicates the selected composite video source which now appears on the screen.
44 R5976491 IQPRO G500 01/02/2007