Service Mode
Change Projector Address
Every projector requires an individual address between 0 and 255. This address can be software installed.
To change that address, push the control disk up or down to highlight Change Proj. Address and press ENTER. The Change Projector Address menu will be displayed and the actual address will be filled in. The first digit is highlighted. Enter the new projector address with:
-the digit keys on the RCU or the local keypath or
-use the control disk to the right or to the left to select a digit and change the value by pushing the control disk up or down until the new value is reached. Continue with the other digits on the same way.
SERVICE
IDENTIFICATION
CHANGE
PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
PRESET INPUT BALANCE
MORE ...
CHANGE PROJ. ADDRESS
Enter new address
001
Select with or
Reprogram with or
or numeric keys
<ENTER> to confirm
<EXIT> to return
Change Baud rate PC
The communication speed between projector and computer, e.g. PC or MAC, has 8 possible speeds. The baud rate speed can be software set up.
Highlight Change Baud rate PC by pushing the control disk up or down and press ENTER to display the Change Baudrate PC.
ENTER displays the Change Baudrate PC menu.
EXIT returns to the adjustment selection menu.
12-8
SERVICE |
IDENTIFICATION |
CHANGE PASSWORD |
CHANGE PROJ. ADDRESS |
CHANGE BAUDRATE PC |
RESET LAMP RUNTIME |
LAMP RUNTIME HISTORY |
PRESET INPUT BALANCE |
MORE ... |
Select with or |
then <ENTER> |
<EXIT> to return. |
5975696BARCODATA2100140798 |
