Power Connection
Lamp Lifetime
30 hours before end of lamp lifetime, the following message will scroll over the screen for 1 minute. This message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.
When the end of the lamp lifetime is reached, the following message, with the exact run time is displayed on the screen.
Lamp run time is 1000* hours. Operating the lamp longer than 1000 *hours may damage the projector. Please replace the lamp.
Remaining |
Lamp run |
time: 20 hours |
When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.
*The total lifetime of the lamp for a safe operation is depending on the type of lamp and on the operating mode. The different values are shown in Table 1.
Do not use it longer. Replace always with a same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Warning : Using a lamp for more than Lamp Lifetime is dangerous, the lamp could explode.
Note: Switching the projector OFF and ON again, adds 45 minutes to the lamp run time.
Article | Dimming / Lamp | Lamp | |
Numbre | Drive Mode | Lifetime | |
|
|
| |
R9829510 | Dimming | 1000 | |
|
|
| |
R9829600 | Economic | 3500 | |
Normal | 2000 | ||
| |||
|
|
| |
R9829740 | Dimming | 4000 | |
|
|
|
Switching to | Switching OFF |
When the projector is running and you want to go to
Caution : Before powering down the projector, switch the projector to
To switch off:
-press first STANDBY key and let cool down until the fans stop blowing ( or at least 15 min).
-switch off the projector with the power switch.
| 5975696BARCODATA2100140798 | |
| ||
|
|
|
|
|
|
