Controlling
c) Point the front of the RCU directly at one of the IR sensors of the Projector Address projector.
a. Software Set Up of the Projector Address.
See 'Change projector address' in chapter 'Service mode'.
B(17)5(5=
| (1)57(5= |
|
|
| Every projector requires an individual address between 0 and 255 | |
|
| Table |
| which can be set in the Service mode. | ||
|
|
| Only projectors with addresses between 0 and 9 can be | |||
|
| Front of projector | Rear of projector | |||
|
| controlled with the RCU. | ||||
|
|
| ||||
|
|
|
| |||
|
|
|
| b. How to Control the Projector or Projectors. | ||
|
|
|
| The projector's address may be set to any value between 0 and 255. | ||
|
|
|
| When the address is set, the projector can be controlled now : | ||
|
|
|
| - RCU for addresses between 0 and 9. | ||
45° | 45° | 45° | 45° | - computer, e.g. IBM PC (or compatible), Apple MAC, etc. for | ||
addresses between 0 and 255. | ||||||
|
|
|
| |||
|
|
|
| Note : a projector will respond to a RCU set to an address of '0' | ||
|
|
|
| regardless of what address is set in the projector itself. |
RCU
c. Using the RCU.
When using the wireless remote control, make sure you are within the effective operating distance (30m (100ft) in a straight line). The remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote control unit and the projector IR sensor.
Before using the RCU, its is necessary to enter the projector address into the RCU (only when that address is between 1 and 9). The projector with the corresponding address will listen to that specific RCU.
When address 0, 'zero address' is programmed into the RCU, every projector, without exception will listen to the commands given by this RCU.
5975696BARCODATA2100140798 |
| |
| ||
|
|
|
