Setup and Installation
Your AVU1500 will...
1.Enter into
a.The background color of the front display (LCD) will change to an orange color.
b.If the
2.Enter Stage 1 and show the approximate
3.If your IR Blaster is set to Stage 1, then an IR signal will be blasted right away. The target device meant to receive this signal should respond.
If not, then there are a few possible reasons (see “Troubleshooting
– IR Blaster” on page 48. Try to make any necessary corrections or adjustments and then run the test again.
4.Shut down power to Stage 1 outlets (any devices connected to Stage 1 power outlets and that were on, will now power off). Remember, this is an accelerated test, so stages will shutdown faster than normal instead of consuming the full
5.Enter Stage 2 and show the approximate
6.If your IR Blaster is set to Stage 2, then an IR signal will be blasted right away.
7.Shut down power to Stage 2 outlets.
8.Enter Stage 3 and show the approximate
9.If your IR Blaster is set to Stage 3, then an IR signal will be blasted right away.
10.Stage 3 will not be shut down (in order to save your connected critical devices).
11.The test will end and your AVU1500 will return to normal operating mode. This will allow you to see what your system will look like after surviving a power outage.
If the system behaves as expected, then congratulations. Your AVU1500 is now ready for use. If the test reveals activities inconsistent with your expectations, then you may have to make adjustments (e.g., connect equipment to different stages). Better to discover these issues now and be able to comfortably rely on your system later.
Belkin PureAV Hybrid AVU1500 UPS
®38
