ADDITIONAL SAFEGUARDS

WARNING: This appliance generates heat and escaping steam during use.

Proper precautions must be taken to prevent the risk of burns, fires, or injury to persons or damage to property.

Never immerse or rinse this appliance in water or any other liquid.

If this appliance accidentally falls or becomes immersed in water, unplug it immediately and do not reach into the water.

Always use oven mitts when touching and/or removing the Lid or accessories.

To reduce the risk of injury, unplug this appliance before inserting food. Always keep the appliance unplugged when not in use.

Be sure to provide adequate space for air circulation above and on the sides when using this appliance. Do not operate near curtains, wall coverings, clothing, dish towels or other flammable materials.

To reduce the risk of fire, do not leave this appliance unattended during use.

Do not attempt to repair a malfunctioning appliance.

Do not place any of the following materials in the Rotisserie: paper, cardboard, plastic, and the like.

Do not attempt to dislodge food or clean the Rotisserie while it is plugged in or still hot.

Do not clean with metal souring pads. Pieces of the pad may break off and touch electrical parts, creating a risk of electric shock.

Do not attempt to use this appliance without the Lid in place.

ALCI Safety Device (On the Plug)

The ALCI safety device is equipped with a test button so that its operation can be checked.

TO USE:

1.Press the reset button on the ALCI safety device.

2.Plug appliance into AC electrical outlet.

3.Then press the test button. The reset button will pop out. This verifies that the safety device is operating properly. Should the reset button not pop out, do not use the unit. Return immediately for service.

Press the reset button to re-activate your ALCI safety device and use your appliance. Repeat this procedure each time this appliance is used, to confirm that the safety device is operational.

At any time, should this unit detect an electrical shock hazard, it will immediately shut off. To restore power, you MUST press the reset button on the ALCI safety device to reactivate the circuit.

THE ELECTRICAL CORD

To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. The cord length of this appliance has been selected to reduce the possibility of tangling or tripping over a longer cord. If additional cord length is needed, an extension cord rated not less than 15 amperes, 120 volts and with the Underwriters Laboratories listing, may be used. If using an extension, be sure to arrange it so that it cannot be pulled or tripped on.

3

Page 4
Image 4
Black & Decker RTS500, RTS600 manual Alci Safety Device On the Plug, To USE, Electrical Cord