Black Box LES1408A, LES1332A, LES144BA Message Changes to configuration succeeded Service Settings

in rackmount models. To modify the default SNMP settings, the Administrator must make the edits at the command line as described in Chapter 15—Advanced Configuration.

TFTP This service will set up the default tftp server on the USB flash card (and is relevant to LES1508A, LES1408A, LES1416A, LES1432A, LES1448A, LES1308A, LES1316A, LES1332A, LES1348A, LES1208A-R2, LES1216A-R2, LES1232A and LES1248A-R2 console servers only). This server can be used to store config files, and maintain access and transaction logs, etc.

Ping The Respond to ICMP echos (i.e. ping) allows the console server to respond to incoming ICMP echo requests. Ping is enabled by default. For security reasons, you should disable this service after initial configuration.

Nagios Access to the Nagios NRPE monitoring daemons (refer Chapter 8)

NUT Access to the NUT UPS monitoring daemon (refer Chapter 10)

SNMP This will enable netsnmp in the console server, which will keep a remote log of all posted information. SNMP is disabled by default. To modify the default SNMP settings, the Administrator must make the edits at the command line as described in Chapter 15 – Advanced Configuration

NTP Refer Chapter 11

Click Apply. As you apply your services selections, the screen will be updated with a confirmation message:

Message Changes to configuration succeeded.

3.4.2Service Settings

The Administrator can access the console server, and connected serial ports and managed devices, using a range of access protocols/services. However for each such access the particular service must first be configured and enabled to run on the console server.

To enable and configure a service:

Select the Service Settings tab on the System: Services page

_____________________________________________________________________

724-746-5500 blackbox.com Page 35