D1260/D1260B Owner's Manual Part II: System Commands - Turning On the System (Arming)

Turning On the System (Arming)

Your security system can be turned on (armed) in many different ways, depending on the arming command used. Arming Commands are those commands used to turn on the system. The most basic arming command is to arm the entire system. The simplest way to arm your system is to enter your personal passcode or press [COMMAND] [1].

There are several other arming commands to turn on the system. These are described later in this manual.

To Turn Your Security System On (Arm):

1.Enter your passcode and press ENTER.

2.The keypad briefly displays AREA 1 NAME TEXT is now arming…,

Turning Off the System (Disarming)

Entering your personal passcode turns off your security system. When the system is turned on, you must enter through a designated entry door to prevent an instant alarm condition. Opening the door starts entry delay time and the Keypad emits a pulsing “beep” tone to remind you to turn off the system. Enter your passcode before the delay time expires and the system will turn off.

If you enter through the wrong door or fail to disarm before the entry delay time expires, you will cause an alarm.

If this happens, silence the alarm (by entering your personal passcode and pressing ENTER) and call your security company to let them know that it is not an emergency situation.

To Turn Your Security System Off (Disarm):

1.Enter your passcode and press ENTER.

and the exit delay tone begins. After exit delay time expires,

the display changes to idle armed text.

5.You must press the ENTER key within 5 seconds of entering your passcode, or the passcode entry will be invalid.

6.The display returns to idle disarmed text.

Turning On the System (Arming) With a Duress Passcode

Your passcode may have a special duress feature that is simply your personal passcode with its last digit increased by 1 or 2.

If an intruder demands that you arm or disarm the security system, you can use your duress passcode. The duress passcode arms or disarms the system and sends an alarm report to your security company. There is no alarm tone or visual indication at the premises that the report is sent. Check with your security company before attempting to use this feature.

16

Bosch Security Systems 9/04 50410D